Two types for your refer:
HC20ASP (Receiver 5V voltage):
- black wire: negative-
- red wire: input greater than 4V to less than 5.3V
- white wire: signal wire
(two red lights, no green light)
HC20ASP-H (Receiver 5V-10V voltage):
- black wire: negative-
- red wire: input greater than 5V to less than 10V
- white wire: signal wire
(only one working red light)
Description:
- Module standby current: about 10 mA. Power consumption current: about 135 mA.
- Dimensions: length 39mm*width 25mm*height 18mm
Application range:
- Remote control model rocket launch
- Remote control model smoke control
- Weapon system control like real machine
- Navigation control of the model aircraft
- Control of various remote switch systems
Functional Description:
- The remote switch remotely controls up to 2 electrical devices on the aircraft model via a switch channel on the remote control
- This device does not require calibration and can be accurately compatible with remote control devices of various brands.
- This device is powered by the receiver and is completely isolated from external power supply, externally powered, and only supplied to the controlled device.
Typical application：
1. Connect
Plug the signal input cable into an idle receiver channel that corresponds to a switch on the remote.
Connect the console switch to the device
2. Trigger
(Take the throttle channel as an example) Turn the throttle lever on the remote control to the full throttle and a relay to close (ie, the terminals are connected). Turn the throttle lever on the remote control to the half throttle, and the two relays are not closed (both are not connected). Turn the throttle lever on the remote control to the minimum throttle and the other relay to close (that is, the terminals are connected).
Package included:
1pcs x PWM relay switch
Note:
- The receiver's 5V voltage is recommended not to exceed 5.3V, otherwise the MCU will be burned out.
- If the receiver and the servo use a high-voltage system, a step-down module should be added to the module.
