2-8S 65A AM32 ESC 32-bit Brushless Electronic Speed Controller 5.2V5A BEC w 14AWG Power Cable

Attention:
- Before sending out the ESC, conduct a rotation test and BEC load test to ensure that all products are of good quality. The buyer needs to have the ability to weld and debug.
- Default using configuration for RC model airplane. Car use needs to be changed to car use mode.

Specification:
- Item name: AM32 brushless ESC
- Master control: AT32F421 120MHZ
- Firmware: AM32
- PCB: 20Z+tin plating+2u gold plating
- BEC: Default 5.2V5A, switchable: 7.3V 8.4V 10.4V
- Input voltage: 2-8S LIPO
- Maximum output current: 65A
- Output peak current: 75A, 3 senconds
- Support offline configuration tools: SerialPortConnector
- Support online configuration tools: esc-confgurator
- PCB board size: 42x25x8mm/1.65x0.98x0.31inch
- Full kit weight: about 29.3g(0.065 pounds)
- Packing list: 1pcs x ESC, 1pcs x XT60H male plug, 2pcs x 14AWG power cable, 1pcs x 3P silicone DuPont wire, 1pcs x shrink film, 1pcs x radiator, 1pcs x capacitor

Features:
- Built-in powerful soft switch circuit, it can effectively turn off the ESC+BEC, just connect the external switch by yourself.
- 4-speed BEC 5.4V to 10.4V 5A output
- Reserve fan and switch solder joints for users to easily connect to the heat dissipation system.
- Reserved through holes for power supply welding, convenient for vertical welding of power lines and capacitors.
- It can be used for FPV drone, fixed wing aircraft, RC crawler car, boat model.
- Supports traditional square wave start-up, fast response, and rapid power output, suitable for propeller models.
- Supports bidirectional rotation and electronic braking.
- It can support PWM, DSHOT, PROSHOT, duty cycle signal and digital ESC signal.
- Supports sine wave start-up, low-speed smooth high torque output, suitable for wheel models. AM32 ESC, torque force compensation.
- This board has been optimized for crawler cars or boat models, and can be connected to an external physical switch for soft turn off operation of the ESC (short-term use). If used for a long time, please unplug the battery and turn off the power.
- The PCB process uses a 4+4 8-layer gold-plated board, with an external copper rod overcurrent for the power board.

Definition:
- S: Signal input port, supporting PWM analog signals, Dshot and other digital signals
- V: BEC output port, default 5.2V-5A output, adjustable to 7.3V-4.5A 8.4V-4A 10.4V-3.5A
- G: GND, connect the negative electrode as the negative electrode of BEC

Note: 
- Size is manual measurement, there are exist errors.
- The video is just for reference, others in video shown will not include.
- The high voltage and high current output of ESC requires natural wind impact heat dissipation, and the use of limited current in enclosed environments of vehicles and ships requires the addition of heat dissipation fins by yourself.

Package include:
1set x AM32 65A ESC