Parameters:
- Voltage: 3-6.5V/DC
- Current: ＜150MA(6V)
- Product size: 43x20x8mm (including pins),
- PCB size: 30.4x18.8x3.5mm (not including pins)
- Weight: 5g (not including wire)
Attention:
- When the receiver is powered on and turned on, all car lights self check and turn off after 1 second of illumination
- The front headlights and tail lights are in the default off state
- Direction CH1 and throttle CH2 can automatically recognize the center position.
Product feature: requires 3 channel controls
- CH1 control turn light+linkage turn signal prompt sound
- CH2 control throttle, brake light, reverse light+linkage reverse prompt sound
- CH3 controls the sound of the speaker
Car lamp control:
The control of the car lights is mainly controlled through the CH1 and CH2 channel values, that is, the working status of the car lights is controlled through the handwheel and throttle trigger, as described below:
- Normal mode: Turn left, left light flashes slowly. Turn right, right light flashes slowly (tick beep prompt sound during linkage steering). Roof light always on. When braking, the brake light on, and when reversing, the backup light on
- Composite mode: Turn the CH1 hand wheel to full lock counterclockwise for 5 seconds to enter the composite mode (if the channel REV is set to reverse, it is clockwise). This mode can be triggered only when the CH2 throttle trigger is not operated. In the composite mode, as long as the CH2 throttle trigger is operated, it will automatically exit the mode
- Enter composite mode:
1. Head light and tail light is on simultaneously, turn off the roof light
2. Rotate the CH1 handwheel counterclockwise once (if the channel REV is set to reverse, it is clockwise), simultaneous explosion flashing mode of head light and tail light
3. Rotate the CH1 handwheel counterclockwise again, four turn light flash slowly, they are alarm lights, emergency light mode+tick tick prompt sound
4. Rotate the CH1 handwheel counterclockwise again, turn off car light
5. Rotate the CH1 handwheel clockwise, (if the channel REV is set to reverse, it is clockwise), exsit composite mode
- CH3 channel controls the sound of the speaker
Note:
- The size is manually measured and there is an error
- If you feel the sound is low, you can replace the speaker by yourself, with a maximum support of 8Ω 5W speakers
Package included:
1set x model car light