1pcs J2 PWM Relay Model Airplane Remote Control Module Switch
Wire Length: 200mm
-Only Supports 5V voltage receiver, otherwise the module may be damaged. If the receiver and steering gear use high voltage system, you should add a step-down module to the module.
-1 channels of steering gear signal input, control 2 channels of electronic switches
-Compatible with remote control equipment of various brands without calibration
Scope of application:
-Remote control model rocket launch
-Remote control model smoke control
-Weapon system control like real machine
-Aviation light control of model aircraft
-Control of various remote switch systems
-This remote switch remotely controls up to 2 electrical equipment on the aircraft model through a switch channel on the remote control
-This device does not require calibration and can be accurately compatible with remote control devices of various brands
-This device uses the receiver to supply power, and the external power supply is only for the controlled device.
Insert the signal input cable into an idle receiver channel, which corresponds to a switch on the remote control
Connect the control switch to the device
(Take the throttle channel as an example) Turn the throttle lever on the remote control to full throttle, and a relay is closed ( that is, the wiring at both ends is connected). Turn the throttle lever on the remote control to half throttle, neither relay is closed (neither relay is connected). Move the throttle lever on the remote control to the minimum throttle, and the other relay is closed(that is, the wiring at both ends is connected).
1pcs x J2 RC Relay Switch