10.5V-26V 100A Bidirectional Brushed ESC High Power Electric Speed Controller UBEC 5V 3A for RC Industrial Motor/Combat Robots
Note: - Multiple ESCs cannot be used to power the receiver at the same time. BEC is a switching regulator, non 7805 - the plug shown in the picture is not included
Specification: -Working voltage: DC 10.5V-26V(3S-6S) -Size: 7.2*3.5*2.4cm -The ESC is NOT waterproof -Peak current(forward or reverse rotate): 100A -ESC Rated power: 1000W -Compatible with all speeds of motors of the same model -Switch UBEC 5V 3A can drive 2pcs 25kg servo. It is not a 7805 linear voltage regulator, so 2 ESCs cannot be used to power the receiver at the same time -Controller input pulse width: 0.8ms--2.2ms, midpoint 1.5ms, suitable for RC plane model device
Advice on how to avoid blocking when the current is too large -Under the 12v circumstance, 3pcs 540 motor or 3pcs 550 motor or 2pcs 775 motor or 2pcs 895 motor or 1pcs 997 motor -Under the 24v circumstance, 2pcs 775 motor or 2pcs 795 motor or 1pcs 895 motor or 1pcs 997 motor
Working mode: (setting by the switch, after resetting, you need to power on again to enter the mode) -Mode 0: control rotate forward or reverse directly -Mode 1: Drag brake (throttle midpoint brake) -Mode 2: Braking force 100
LED indicator: -Always on: Working normally -Intermittent flash: This means when it's power on, the throttle is not at a middle safe place -Continuous flash: Lost throttle signal -Power on, LED indicator flash 3 times slowly to self-check, then always on, which means it can work normally -When the ESC is powered on and the throttle is not at the middle point, LED will intermittently flash. you have to adjust the throttle to the middle point, then LED always-on, otherwise, the ESC cannot work -Lost throttle signal will cause led flashing and motor will stop working
Application: -Used for combat robots, industrial motor, etc.
